Biker And Bike 3.95

FULL RANGE OF SERVICES

Minor and Major Mechanical Repairs

Engine, Primary Chain-Case, Transmission, Clutch etc
Minor and Major Electrical Repairs

All types of electrical repairs and modifications, wires and switches, harnesses, dashboard instrument panel, music systems, theft alarms, cosmetic lighting etc... , repair, replace or install new.
Tailor-Designed Customizing

Installation of any readymade customized parts manufactured by a third party, and fabrication of individually designed parts by Biker & Bike.
Chroming

Re-chrome faded, scratched, damaged existing parts, or newly fabricated parts. (Many colours).

*(Chrome plating will generally go through these different stages:

Degreasing to remove heavy soiling.
Manual cleaning to remove all residual traces of dirt and surface impurities.
Various pre-treatment's depending on the substrate.
Placement into the chrome plating vat, where it is allowed to warm to solution temperature; and application of plating current, under which the component is left for the required time to attain thickness)*

Electronic Diagnostic and Fault Repairs

Real-time Engine Parameters data, RPM, Throttle Position Sensor, Battery Voltage, Lambda and system information.
Check and clear Diagnostic Trouble Codes (DTC) from ECU (Engine Control Unit).
Check & clear Diagnostic Trouble Codes (DTC) from TSSM (Turn Signal/Security Mode).
Calibration settings such as: Idle Fuel Trim adjustment, idle adjustment.
Reset TPS (Throttle Position Sensor), actuator, AFV (Air Fuel Value), maintenance light, and more.
Perform Active Test on Tachometer, Injectors, Coils, Purge Solenoid, Idle Speed Control and more.


State of the Art Engine Chip Tuning

Biker & Bike Software package is a high end system that is compatible with Marelli and Delphi systems on all EFI Harley-Davidson bike models up to date. Our EFI Tuning system gives our technician the best and most accurate tenability.

Re-flash calibrations maps programmed onto the ECU
Modify the tables: front & rear cylinder fuel & spark table, Air Fuel Ratio, Warm-up, Cranking, Idle, Acceleration, Rev-limiter, and more
Fuel & Spark table real time cell tracing
Simultaneously modify both front and rear spark & fuel tables
Record all data
Alternate data capture positions: start/middle/end
View and adjust real-time data (RPM, TPS, PWM, 02 Sensor, etc)
Test and modify External Lambda sensor

(The exhaust gas oxygen sensor (EGO or O2), or lambda sensor, is the key sensor in the engine fuel control feedback loop. The software uses the O2 sensor's input to balance the fuel mixture, leaning the mixture when the sensor reads rich and enriching the mixture when the sensor reads lean)*
Modifications

Changing of handlebars, headers, slip-ons, rims, wheels, tires, cables, switches, fenders, gas tank, air filter etc.
Accessories

We are proudly associated with darrajeh.com/ providing a huge range of accessories
Polishing

When your bike requires reviving, polishing rejuvenates it to its original beautiful factory colour. We use some a comprehensive range of the best polishing products.
Detailing

When each and every reachable part is carefully hand-cleaned and restored to the best possible original condition, hand-polished, and then finished off with a beautiful coat of wax to leave it sparkling and looking as good as new.
Biker & Bike Detailing

This is a one off service we provide our customers and bikers, when you feel you want to give
Your baby some TLC.

Riding in our harsh, sandy, humid environment, over time grime, mud, salt, and other solids accumulate under the body parts and inside the bike, where regular washing can't reach, over time those deposits corrode and fatigue many unseen parts of the bike which in turn leads to a massive damage and repair bill.

Biker and Bike will remove all the bike parts, degrease and carefully clean off all the accumulated grime and solid deposits, and clean the chassis and all removed parts, inspect cables, rubbers etc for any damaged or are in need of replacement, check for corrosion and then inform the biker if he/she wishes to replace them. Those recommended parts will then be replaced while the bike is apart, all parts are carefully hand cleaned and polished, treated, then reassembled back leaving the bike looking close its original showroom condition.
Shampoo Washing

This service is carefully administrated using the right amount of water pressure. Unlike the regular wash stations who use high water pressures which leads to damage to your bike caused by high pressure water being forced into many parts which in turn leads to humidity build up in speedometers and other gauges and more often than not this leads to electrical failures.
We use the correct pressures washing the road and environment dirt off and then we hand wash the bike with specially formulated bike shampoo protecting the paint. This is followed by air drying ensuring all the water is displaced from all parts of the bike and finally hand towel dried to a sparkling finish.
Paintwork

Painting, changing of the existing factory paint schemes, or paint repairs and touch ups.
Custom Paint and Airbrushed Art Work
Custom paint to identify your individuality and stand out from the crowd with custom designs and allow you to be the only one on the planet with your design. The airbrush artist will assist you designing and transferring your thoughts and imagination onto your bike.
Upholstery

Recover your seat, backrest, passenger seat and backrest using many types of leather, chamois leather or suede and weatherproof leather, in many designs and colours and distinguished stitching.
Apparel

Our store offers one-off biker t-shirts, vests, jackets, bandanas, helmets, bike accessories, useful electrical extras etc which are usually not available except at Biker & Bike. Indulge yourself with many designs to suite your riding style, keeping in mind the high quality you are used to and expect.
Bikers Accessories

This is where you can find gadgets that you'd like to have, useful little things to have on the road, for audio, entertainment, navigation, video recording etc.